Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is it possible to connect two ima interfaces back to back?

I have two ima interfaces, one NM and one PA, is it possible to connect them back to back ?

2 REPLIES

Re: Is it possible to connect two ima interfaces back to back?

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Is it possible to connect two ima interfaces back to back?

Hi,

Yes, you can do this. But the iisue is the CLOCK. Otherwise I did it and no problem.

Regards

85
Views
0
Helpful
2
Replies