Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Is it possible to use multilink on a Cisco 803 and dial to two locations.

Is it possible to use multilink on a Cisco 803 and at the same time dial to a other location so that one multilink channel is disabled and is used for a connection to the other location.

1 REPLY
Anonymous
N/A

Re: Is it possible to use multilink on a Cisco 803 and dial to t

Yes. Configure 2 dialer maps (or

two dialer profiles), and then use the

"dialer fast-idle" command to control

when the second channel in the MPPP

bundle will be torn down so that a

call to the second location can be made.

This command controls the timing when

there is dialing contention like this.

90
Views
0
Helpful
1
Replies
CreatePlease to create content