Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams?

Now am practicing for BSCI and BCMSN.I don`t have any facility to do labs.

1)  Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams..?

    

     And i could find layer 2 switchs in packet tracer 5.1.

2) ip helper-address will support in layer 2 switches..?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Is packet tracer 5.1 or 5.2 enough to simulate all labs of C

Now am practicing for BSCI and BCMSN.I don`t have any facility to do labs.

1)  Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams..?

     And i could find layer 2 switchs in packet tracer 5.1.

2) ip helper-address will support in layer 2 switches..?

Hi,

Packet tracer 5.1 is good for practising labs for CCNP routing or switching and also you can try GNS3 for real time simulation of labs for CCNP and for your second question  L2 switch supports VLANs, but cannot route traffic from one VLAN to another without help from another L3 device to do the routing.

You will need to configure a trunk port to whatever device you use for routing, and configure the ip helper-address on each subinterface or vlan interface you setup on the L3 device.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

3 REPLIES

Re: Is packet tracer 5.1 or 5.2 enough to simulate all labs of C

Now am practicing for BSCI and BCMSN.I don`t have any facility to do labs.

1)  Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams..?

     And i could find layer 2 switchs in packet tracer 5.1.

2) ip helper-address will support in layer 2 switches..?

Hi,

Packet tracer 5.1 is good for practising labs for CCNP routing or switching and also you can try GNS3 for real time simulation of labs for CCNP and for your second question  L2 switch supports VLANs, but cannot route traffic from one VLAN to another without help from another L3 device to do the routing.

You will need to configure a trunk port to whatever device you use for routing, and configure the ip helper-address on each subinterface or vlan interface you setup on the L3 device.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

New Member

Re: Is packet tracer 5.1 or 5.2 enough to simulate all labs of C

Thank you Ganesh.H,

I installed GNS3,but it is asking to register with atleat one ios.so how we wil do that...?

Re: Is packet tracer 5.1 or 5.2 enough to simulate all labs of C

Thank you Ganesh.H,

I installed GNS3,but it is asking to register with atleat one ios.so how we wil do that...?

Hi,

You need to have a ios to run the router in the GNS3 if you have cco account you can download or from other sources you can have it to run the router emulation succefully.

Hope to help !!

Ganesh.H

Remember to rate the helpful post

1564
Views
0
Helpful
3
Replies