Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is there a command on the router, so I can find out the frame-relay encapsulation type of the switch ?

If unknown on the switch, is there a sh or deb command on the router to detect the encapsulation type of the switch ?

  • Other Network Infrastructure Subjects
1 REPLY
Anonymous
N/A

Re: Is there a command on the router, so I can find out the fram

NO there is no command or debug to help you with this.

IOS 11.2 do auto sensing for the three lmi flavours

and when one is detect on the swicth it is used locally on router

and you can verify by doing "sh frame lmi".

As I'm not quite sure if LMI was disabled in newer releases, the only way

to know for sure is use each LMI type the the link

becomes active indicating that the right LMI is set.

76
Views
0
Helpful
1
Replies
This widget could not be displayed.