Is there a way to see all of the configurations for a router including values that are set to default?
Normally when you do a show run items that have not been changed from the default do not show up. For example if you turn off ip roue-cache it appears,no ip route-cache, if you enable it nothing shows in the show run or show start. I want to see it all regardless if it is a default value or not. I am working with mainly routers (2600,3600,7200,1700) running 12.0 through 12.2 T code.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...