Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Is this a 2801 config problem ?

Hi

I have a pair of 2801 routers. One at each end of our 10 meg WAN link. I can ping hosts on each network (10.1.0.0/16 10.2.0.0/16)from both sides, but I seem to be getting a lot of errors. Is it a configuration problem? The configs and a 'tail -n 100' of the log is attached.

Thanks for any response

Kev

Bolton 6th Form College

UK

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Is this a 2801 config problem ?

Looks as if your WAN link suffers from duplex mismatches. Please check with the provider that your settings are correct.

If you administer the link yourself, check that it does not exceed limits for cable lenght & number of repeaters.

Regards,

Leo

1 REPLY

Re: Is this a 2801 config problem ?

Looks as if your WAN link suffers from duplex mismatches. Please check with the provider that your settings are correct.

If you administer the link yourself, check that it does not exceed limits for cable lenght & number of repeaters.

Regards,

Leo

96
Views
0
Helpful
1
Replies
CreatePlease to create content