What is the recommended bandwidth value for an ISDN BRI interface? Should it be left at the default of "64" for the purposes of the "dialer load-threshold" command calculations or should it be adjusted to "128" to reflect the two "B" channels that are available?
The bandwidth command is used for routing decisions....changing the bandwidth on the BRI (the D channel) will not change the BW under the B1 & B2 channels which defaults to 64k....the dialer load threshold is based off the load on these bearer channels (B1, B2).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...