Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

isdn bri voice doesn't act as an NT interface

connecting my VIC-1b S/T TE/NT to a Nortel PBX layer 1 does not go up.

<p>I used a crossed cable.and this is my config:

<p>interface BRI1/0

<p>no ip address

<p>no ip directed-broadcast

<p>isdn switch-type basic-net3

<p>isdn overlap-receiving

<p>isdn skipsend-idverify

<p>isdn incoming-voice voice

<p>I configured also the voice-port 1/0/0

and I dial peer pots.

1 REPLY
Anonymous
N/A

Re: isdn bri voice doesn't act as an NT interface

Your config seems wrong. You did not specify that

the interface should emulate the network side

and slo layer1 parameters was not specified.

See the sample config below.

interface BRI1

no ip address

isdn switch-type basic-net3

isdn protocol-emulate network

isdn layer1-emulate network

isdn incoming-voice voice

isdn T306 30000

isdn skipsend-idverify

no cdp enable

209
Views
0
Helpful
1
Replies