Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ISDN call....have you seen this error

Hello all, I'm tring to initiate an ISDN call from a Cisco 7513 to a remote 2611 router. I'm getting this error:

Aug 6 15:27:06.690 CDT: ISDN BR1/0: Incoming call id = 0x0057, dsl 8

Aug 6 15:27:06.690 CDT: ISDN BR1/0: received HOST_INCOMING_CALL call_id 0x57

Aug 6 15:27:06.690 CDT: ISDN BR1/0: HOST_INCOMING_CALL: (non-POTS) DATA

Aug 6 15:27:06.694 CDT: ISDN BR1/0: HOST_INCOMING_CALL: (1) call_type = DATA

Aug 6 15:27:06.694 CDT: ISDN BR1/0: HOST_INCOMING_CALL: voice_answer_data = FAL

SE call type is DATA

Aug 6 15:27:06.694 CDT: ISDN BR1/0: RM returned call_type 0 resource type 0 res

ponse 1

Aug 6 15:27:06.698 CDT: ISDN BR1/0: isdn_send_connect(): msg 4, call id 0x57, c

es 1 bchan 0, call type DATA

Aug 6 15:27:06.698 CDT: %LINK-3-UPDOWN: Interface BRI1/0:1, changed state to up

Aug 6 15:27:06.870 CDT: ISDN BR1/0: received HOST_CONNECT call_id 0x57

Aug 6 15:27:06.870 CDT: ISDN BR1/0: Event: Connected to 3124254847 on B1 at 64

Kb/s

Aug 6 15:27:07.920 CDT: ISDN BR1/0: Event: Hangup call to call id 0x57 ces = 1

Aug 6 15:27:07.924 CDT: ISDN BR1/0: process_disconnect(): call id 0x57, call ty

pe is DATA, b_idb 0x80CF28E8, ces 1, cause Normal call clearing(0x10)

Aug 6 15:27:07.928 CDT: %ISDN-6-DISCONNECT: Interface BRI1/0:1 disconnected fr

om 3124254847 cr-core-lit1, call lasted 1 seconds

Aug 6 15:27:08.052 CDT: ISDN BR1/0: received HOST_DISCONNECT_ACK call_id 0x57

Aug 6 15:27:08.056 CDT: ISDN BR1/0: HOST_DISCONNECT_ACK: call type is DATA

Aug 6 15:27:08.056 CDT: %LINK-3-UPDOWN: Interface BRI1/0:1, changed state to do

wn

this is the debug isdn events output on the remote router receiving the call.

any help would be greatly appreciated.

respectfully

jm

2 REPLIES
Silver

Re: ISDN call....have you seen this error

Better debugs to run would be "deb isdn q931" "deb ppp nego" on both the ends.

Thanks, Mak.

Silver

Re: ISDN call....have you seen this error

can you paste in the config from both sides

91
Views
0
Helpful
2
Replies
CreatePlease to create content