Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

isdn call interface command not working correctly ??!!!

Due to some reason, my PRI router need to be configured multiple dialer profiles with multiple dialer pool-member #. The "isdn call interface" command does not succesfully carry out and failed when display by using the show isdn history command. This command previously was working fine when only single dialer profile is used with dialer rotary-group feature (multiple dialer-map commands).

Any expert has this experience before ?? is it limited and can not use "isdn call interface" when using multiple dialer profiles in single physical interface ??? Please advise and thanks in advance.

Regards,

Danny

1 REPLY
New Member

Re: isdn call interface command not working correctly ??!!!

It would help if you could post your configs.

These links might help!

http://www.cisco.com/warp/public/129/23.html

http://www.cisco.com/en/US/tech/tk801/tk379/technologies_tech_note09186a0080094b21.shtml

http://www.cisco.com/en/US/tech/tk801/tk379/technologies_tech_note09186a00800c7d61.shtml

Although they are for BRI they should work for PRI interfaces also.

Hope this helps!

74
Views
0
Helpful
1
Replies
CreatePlease to create content