Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN Dialer Profile Problem

Hi,

I have configured a router with two Dialer Profile. However, I can dial a call to remote site with the dialer profile but cannot receive call.

I've got these message (using debug dialer) when remote router try to dial in.

"ISDN BRI0:1 Incoming call rejected, unbindable"

Is there any setting required?

Thanks.

Regards,

Douglas

2 REPLIES
VIP Purple

Re: ISDN Dialer Profile Problem

Hello Douglas,

without having seen your configuration I can only guess, but check if ´ppp authentication chap | pap [callin]´ has been configured on the physical interface of the devices.

Can you post the configurations of the routers ?

Check this document for troubleshooting info and possible causes:

Configuring and Troubleshooting Dialer Profiles

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_tech_note09186a0080094e6c.shtml

Regards,

Georg

New Member

Re: ISDN Dialer Profile Problem

Hi Georg,

I found that after I use the "dialer caller" command on the dialer interface, I can dial in from remote. However, if the call is long distance call, can I use the dialer caller command too?

Thanks.

Regards,

Douglas

90
Views
0
Helpful
2
Replies
CreatePlease login to create content