I need to configure a 1721 router in Wellington, New Zealand to dial into a router located in Sydney, Australia. I have all the local ISDN number allocated to me by the carrier already but was wondering whethere I need to put in the IDD dialing code on the Wellington router or not? If yes then can someone provide me a sample number? ie i'm not sure whether i have to put in the full dialing code or is it just +61 2 xxxxxxx. Thanks in advance for your help.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...