Rollover happens, when one line is busy and the call is then placed on to the second line. This can happen if the call has not torn down on line 1, and appears to be busy, due to which call is placed on line 2.
Have you setup any hunt groups on your BRI lines ? If not try increasing rollover delay by using the command,
isdn fast-rollover-delay X ()
This will delay the second call by X seconds. (gives enough time to tear down the first call).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...