I have 2 Cisco 803 routers, when I connect them to our college Alcatel PABX, I cannot get a TEI. When I type show isdn status, all I get is Layer 1 - Deactivated! (the same when I use a 1721 Router... Deactivated)
If I connect my Cisco 2503 to the same ISDN port, the switch assigns me a TEI number.
Any ideas what is wrong? I am pointing to the Alcatel switch. I have tested all routers via a BT ISDN line and everything works...
If the config (hardwar and software) is same on all the routers. If it works on 2500, No reason for not to work on 1721 and 803. Make sure that you have BRI-U iand not S/T interface on 803 and 1700 too.
Here is the preety good url for "troubleshooting LAYER 1 on isdn bri line"
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.