I am looking at setting up ISDN from a remote IR router in Area 130 back to a AS5300 in Area 0. I am looking at On-Demand Circuits. I do not want my IR to become a ABR and do not want the ISDN interface in Area 0.
You can consider using just static default route and if you still need to make that remote router part of OSPF AS, then configure it as " ip ospf demand-circuit " on the aS5300 side and make sure read this tech tip
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...