Is it possible to use an ISDN BRI interface to call an asynchronous V.90 modem? I would like to set up an IP based dialer map on the ISDN interface to call remote sites with V.90 modems that support PPP. Any examples or sugesstions would be appreciated. Thanks.
You need to have modem connected with a modem..So in the router with isdn line, if you have digital modem, then you can use that digital modem to callout over isdn line to connect to analog modem..So the requirement is to have a digital modem in the router..We have a product called 3600 router, which supports modem dialout/dialin over bri lines..Hre is the url for more info.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...