Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN PRI Could not dial out

Messages follows:

dx-01#show isdn sta

14w5d: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet1/0 (no

t half duplex), with 2924-beishytw.bj.cncnet.net FastEthernet0/1 (half duplex).s

er 4/0:15

Global ISDN Switchtype = primary-net5

ISDN Serial4/0:15 interface

dsl 1, interface ISDN Switchtype = primary-net5

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

TEI = 0, Ces = 9, SAPI = 16, State = TEI_ASSIGNED

Layer 3 Status:

0 Active Layer 3 Call(s)

Activated dsl 1 CCBs = 0

The Free Channel Mask: 0xFFFF7FFF

Total Allocated ISDN CCBs = 0

dx-01#show isdn sta ser 4/0:15

Global ISDN Switchtype = primary-net5

ISDN Serial4/0:15 interface

dsl 1, interface ISDN Switchtype = primary-net5

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

TEI = 0, Ces = 9, SAPI = 16, State = TEI_ASSIGNED

Layer 3 Status:

0 Active Layer 3 Call(s)

Activated dsl 1 CCBs = 0

The Free Channel Mask: 0xFFFF7FFF

Total Allocated ISDN CCBs = 0

dx-01#ping 10.1.3.102

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 10.1.3.102, timeout is 2 seconds:

14w5d: ISDN ERROR: Module-CCPRI Function-CCPMSG_OutCall Error-Bad data in HOS

T message to CC: 4.....

Success rate is 0 percent (0/5)

dx-01#

dx-01#

14w5d: ISDN IDB for call 0x%x: Event: Could not find B-channel

1 REPLY
Bronze

Re: ISDN PRI Could not dial out

Can please checkout your configurations with the configuration given in the below link, I think you have missed out to associate the PRI lines to a interface dialer ,

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093ffc.shtml

For troubleshooting tips refer the link below use the debug commands to isolate the problem.

http://www.cisco.com/en/US/tech/tk801/tk379/technologies_tech_note09186a0080143175.shtml#troubleshootingoutboundcalls

425
Views
0
Helpful
1
Replies