01-31-2003 06:42 AM - edited 03-02-2019 04:43 AM
I am trying to configure a 2610 Pri ISDN2 E1 to dial out to our remote sites. I have managed to configure the router so that remote sites can call in, but not out. Not much use when I need to manage the remote routers! Shiva Access Ports are used at the remote sites. Can anybody send me an example configuration or give any idea where I am going wrong. Any informtion would be much appreciated.
Mark
01-31-2003 07:30 AM
Mark,
Please show your config and the "debug dialer events" and "debug isdn q931" output when you are attempting to dial out.
Mark
01-31-2003 09:55 AM
First you need to make sure that the E1/PRI line is in sync with telco switch on layer 1 and 2..For that following link will help you.
http://www.cisco.com/warp/public/116/E1_pri.html
Once you have verified that layer 2 status is "Multile_Frame_Established" you need to turn on following debug and call in the 2600 router
debug isdn q931
debug ppp nego
debug ppp authentication
term mon
debug isdn q931 will inform you that the call is received/sent from the telco switch or not. Here is the url for more on that..
http://www.cisco.com/warp/public/471/isdn_q931_ts.html
Post the debug with running config as well.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: