Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN PRI (E1) interface error

I have installed one port channelized E1/ISDN PRI to my Cisco 2600 router.

After install I observed that the local alarm LED (orange light ) is on.

What that means ? Do the interface have an hardware problem ?

1 REPLY
Anonymous
N/A

Re: ISDN PRI (E1) interface error

The alarm means that there is a "loss

of signal, loss of frame, or unavailability

because of excessive errors".

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/hw_inst/nm_inst/nm-doc/conntpri.htm

"sh controller" should verify this, too. You may

want to confirm your framing, linecoding, physical

cabling, and work with the carrier to try some loopback

testing to try and understand where the problem

might be.

93
Views
0
Helpful
1
Replies