I have set up a Cisco Router (1600) for dial on demand purposes for a client and the problem is that the router dials out intermitently and the client ends up with huge bills. Looking at the bill it shows the router dialing up at intervals like every 10 minutes or 15 minutes apart.
I have set up rules to filter off UDP packets on Ports 127,138 and 139. This helped but did not cure it. The problem actually is not just during the day but during the night as well
SHOW DIALER should tell you the dial reason. Probably SNMP polls or traps. Use the access-list option on the dialer-list to drop IP broadcast destinations and SNMP as well. Switch off CDP on the interface. This may help...
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...