I have two routers dialing into a central router using dialer-watch. The routers dial properly, however after the primary circuit comes up, the routers drop the calls, logs show both channels disconnect from the number. However in show dialer it shows call state as call being disconnected. This is only happening on the second B channel as the first is properly diconnected. It appears that either the release or release_comp is being ignored or dropped somewhere. These are 17xx routers running 12.1(5)10T. Any bugs i couldnt find? Thanks.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...