Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN Setup

We are a start up ISP. We want to setup a customer with 128k ISDN connection to the internet. We have a AS5300 with mica modems. How should I go about setting this up? Will I need any further equipment to support ISDN connections on my AS5300?

Thank you..

3 REPLIES
New Member

Re: ISDN Setup

You won't need any more equipment. With MICA modems and a PRI you can support analog modem calls or ISDN PPP multilink calls.

Configure ppp multilink on the ISDN modem.

AS5300

controller T1 0

framing esf

clock source line primary

linecode b8zs

cablelength short 133

pri-group timeslots 1-24

interface Serial0:23

no ip address

encapsulation ppp

dialer rotary-group 1

dialer-group 1

isdn switch-type (SWITCH TYPE provided by your carrier)

isdn incoming-voice modem

no cdp enable

ppp authentication pap

interface Group-Async1

ip unnumbered Loopback0

encapsulation ppp

dialer in-band

dialer idle-timeout 1800 either

dialer-group 1

async dynamic address

async mode interactive ( this is what allows ISDN or analog calls)

peer default ip address pool dialin_pool

no cdp enable

ppp authentication pap

group-range 1 192 (make sure you put the number of modems you have) 1 24 ?

!

interface Dialer1

ip unnumbered Loopback0

encapsulation ppp

dialer in-band

dialer idle-timeout 1800 either

dialer-group 1

no peer default ip address

no cdp enable

ppp authentication pap

ppp multilink

ip local pool dialin_pool (DHCP range you are handing out)

New Member

Re: ISDN Setup

Thank you very much Ryan

New Member

Re: ISDN Setup

Ok, I think I have the ISDN connection setup. Now could you tell me how I would setup the Win95 workstations to access this ISDN connection on a dial-on-demand basis. This workstations are all connected via a workgroup LAN connection.

Thank you.

264
Views
0
Helpful
3
Replies
CreatePlease login to create content