I have a ISDN Simulator with two U ports.I have two routers with BRI-U interface connected to the U ports.One of the router is working fine.Other is not working.when i type show isdn status -it is showing layer 1 deactivated.
Did you check the switch settings on that port, to match with the switch setting configured on the router BRI port ? Try resetting the simulator BRI port and see if it comes up. Check the cable between the simulator and the router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...