I require some information on how to configure a 3640 router to allow ISDN dialup over an E1 link, from a PC with an ISDN terminal adapter. My router already is configured to allow PSTN dialup, and also ISDN dialup from 800 and 1600 routers. However, when I try to connect from a PC (Windows 2000) with a TA, I get the message below:
Check networking protocol connections...
TCP/IP CP reported error 733: Your computer and the remote computer could not agree on PPP control protocols.
I have followed the advice on the Microsoft Knowledge Base but this has not resolved the problem, therefore I believe it may be a router config issue, probably in the PPP authentication.
I would be grateful if you could point me in the direction of some sample configs for the 3600 for this as I have been unable to find them on the TAC website.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...