Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN top-up for WAN circuit

Is it possible to use a 'top-up' of ISDN2 based on load for a point-point synchronous serial connection? If so can this co-exist as a back-up route using 'floating static' or is a seperate dialer interface required?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: ISDN top-up for WAN circuit

You can use the backup load command on your serial interface in conjunction with the backup interface command

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c/fnsprt6/dcdbaks.htm#xtocid9

1 REPLY
Silver

Re: ISDN top-up for WAN circuit

You can use the backup load command on your serial interface in conjunction with the backup interface command

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c/fnsprt6/dcdbaks.htm#xtocid9

85
Views
0
Helpful
1
Replies
CreatePlease to create content