ISDN

[carl_townshend]

I have configured my bri 0 interface to dial out on anything, why cant I ping the other end, The light doesnt come on , on the front of mt 1700 router ? the router the other end does not have a password, should this still work ?

[thisisshanky]

Lets look at your configs. Also paste a sh isdn status as well at either ends.

[carl_townshend]

interface BRI0

ip unnumbered FastEthernet0

no ip route-cache

dialer map ip 10.40.24.4 name ndu-welcome xxxxxxxxxxx

dialer-group 1

isdn switch-type basic-net3

no fair-queue

dialer-list 1 protocol ip permit

ip route 10.40.24.0 255.255.255.0 10.40.24.4

[thisisshanky]

You did not paste output of sh isdn status -> this is to verify that your isdn interface is working properly.

You dont need the password as long as you dont use authentication.

You can additionally use PPP encapsulation, "encapsulation ppp" under the bri interface. (both ends).

If possible, paste output of debug dialer to see whats happening.

[carl_townshend]

here it is !!

WELCOME#sh isdn status

Global ISDN Switchtype = basic-net3

ISDN BRI0 interface

dsl 0, interface ISDN Switchtype = basic-net3

Layer 1 Status:

ACTIVE

Layer 2 Status:

TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

I_Queue_Len 0, UI_Queue_Len 0

Layer 3 Status:

0 Active Layer 3 Call(s)

Active dsl 0 CCBs = 0

The Free Channel Mask: 0x80000003

Number of L2 Discards = 0, L2 Session ID = 12

[carl_townshend]

Can anyone help

[rgodden]

broadcast statement required on dialer map

[carl_townshend]

what is that ? and how do I set that up ?