09-20-2005 08:02 AM - edited 03-03-2019 12:06 AM
I have configured my bri 0 interface to dial out on anything, why cant I ping the other end, The light doesnt come on , on the front of mt 1700 router ? the router the other end does not have a password, should this still work ?
09-20-2005 08:18 AM
Lets look at your configs. Also paste a sh isdn status as well at either ends.
09-20-2005 08:22 AM
interface BRI0
ip unnumbered FastEthernet0
no ip route-cache
dialer map ip 10.40.24.4 name ndu-welcome xxxxxxxxxxx
dialer-group 1
isdn switch-type basic-net3
no fair-queue
dialer-list 1 protocol ip permit
ip route 10.40.24.0 255.255.255.0 10.40.24.4
09-20-2005 01:07 PM
You did not paste output of sh isdn status -> this is to verify that your isdn interface is working properly.
You dont need the password as long as you dont use authentication.
You can additionally use PPP encapsulation, "encapsulation ppp" under the bri interface. (both ends).
If possible, paste output of debug dialer to see whats happening.
09-21-2005 12:11 AM
here it is !!
WELCOME#sh isdn status
Global ISDN Switchtype = basic-net3
ISDN BRI0 interface
dsl 0, interface ISDN Switchtype = basic-net3
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 64, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
I_Queue_Len 0, UI_Queue_Len 0
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Number of L2 Discards = 0, L2 Session ID = 12
09-23-2005 12:15 AM
Can anyone help
09-23-2005 01:28 AM
broadcast statement required on dialer map
09-23-2005 02:04 AM
what is that ? and how do I set that up ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide