Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISIS Adjacency

Hi All,

What criteria should be matched each other, when two isis peers establish adjacency?

Thanks in advance

5 REPLIES
Bronze

Re: ISIS Adjacency

Level, hello interval, dead interval, authentication. There may be others... LAN ID perhaps?

New Member

Re: ISIS Adjacency

Thank you for your reply. But when I tried to change hello interval and dead time on one interface (isis hello-interval and isis hello-multiplier), I still could make neighborship and adjacency. From cisco's ISIS document they said the main criteria are matching authentication, IS-type and MTU size. I need to know if there are other factors. Thanks.

vdk
New Member

Re: ISIS Adjacency

Hi,

has your problem been fixed? I have a similar one...

Vincent

Silver

Re: ISIS Adjacency

Those three criteria are all that are needed to match, although on certain (e.g. Frame Relay) NBMA types there needs to be a mapping of CLNS to have ISIS come up. Can you describe the details of your problem? Example of your configs might help as well.

Regards,

Don

New Member

Re: ISIS Adjacency

Here is the other factors that must be met in order to form adjacency:

1: Length of system ID

2. Maximum number of Areas. Previously Cisco support 3 and now it can be set to 255.

3. Authentifcation.

4. Media type i.e. point-to-point or broadcast media

288
Views
0
Helpful
5
Replies
CreatePlease login to create content