R1 and R2 in area 1, R3 in area 2. I establish ISIS and I can see all the routes. But when I use area-password and domain-password commands, it seems that they don't work. When I enable area and domain password in R2 but not R1 and R3, the routes still knows the routes. But when I use debug command, I can see the LSP authentication failed. Can any body explain it? Thank You!
Do you clear the ISIS adjacencies after putting on authentication? If not pls try this. If the adjacencies come up then, assuming you did not clear them after applying your authentication, and LSPs/Routes are exchanged then there is a problem.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...