Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

isis redistribute to ospf problem

Hello,

I configure isis and ospf redistribute like this:

R1---12net---R2----23net----R3

ISIS L2 OSPF

When I redistribute ISIS into OSPF on R2 , I see any other ISIS routes behind R1 but I don't see the 12 network which is connecting the two of them. I have seen this on both Frame Relay and Ethernet, I have used a redistributed connected matching a route-map to get the network into the table but is there any other way?

2 REPLIES
Bronze

Re: isis redistribute to ospf problem

Take a look through the following link on setting up IS-IS for more information on configuring redistribution.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/np1_c/1cisis.htm

Silver

Re: isis redistribute to ospf problem

If you have a network statement in your ospf config for the 12 network this network will be preferred over ISIS since the AD of ospf is 110 and ISIS is 115.

121
Views
0
Helpful
2
Replies
CreatePlease login to create content