I'm having a couple problems with mutual redistribution between ISIS and EIGRP.
A little setup, I was trying to redistribute only level-1 routes into EIGRP and it would redistribute both L1 and L2 routes. I know that I have both L1 and L2 routes in the routing table on the redistribution router. The configuration I've been using is:
The following output shows an IS-IS router redistributing static, RIP, IGRP, EIGRP, and OSPF routes.
redistribute rip metric 20
redistribute igrp 1 metric 20
redistribute eigrp 1 metric 20
redistribute ospf 1 metric 20The IS-IS metric must be between 1 and 63. There is no default-metric option in IS-IS?you should define a metric for each protocol, as shown in the example above. If no metric is specified for the routes being redistributed into IS-IS, a metric value of 0 is used by default.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...