Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISO CLNS Access Lists!!!

I am trying to create distribution lists on Cisco 2500 series routers for CLNS prefixes(L2). I am running IS-IS and want to advertise only certain NSAP area ID's to certain routers. After looking on Cisco's web site(under access lists) I have found documents which state that you can create a named access list for ISO CLNS but I have not been able to do this with any IOS I have used. After further reading I discovered that CLNS access lists can be created by using template-aliases, filter-sets and filter-expressions, however, when I come to create the distribution list under the "router isis" config. prompt it asks for the access-list name and at this point I substitute the filter-set name, the command is accepted but unfortunately doesn't actually work!!!(I have also tried substituting the filter-expression name but this does not work either) What am I doing wrong??? Could any kind expert out there please advise on how to achieve the desired aim???!!! Please e-mail any answers/suggestions/comments to julian.miller@ntl.com

1 REPLY

Re: ISO CLNS Access Lists!!!

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

225
Views
0
Helpful
1
Replies