Kindly help me in improving my through tunnel throughput
Our two offices in two different cities, they are connected to eachother through internet bandwidth. At both the places, each office cisco router is connected with their near by ISP. Now we creat a GRE Tunnel from ethernet to ethernet for all data transfer between our offices internal network. here is my configuration at one side, the same is at other side.
GEO-LAHORE#show inter ser 0/0
Serial0/0 is up, line protocol is up
Hardware is PowerQUICC Serial
Description: 256k radio link->COMSATS LHR
Internet address is 188.8.131.52/30
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 6/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
0 output buffer failures, 0 output buffers swapped out
I am using EIGRP as routing protocol.
I have 256 kbps bandwith at each site. While browsing internet I get throughput 20 to 25 KBites, but when I transfer files suing ftp at our internal network, browse some our internal web site that uses tunnel offcource, the throughput is only 2 to 4 KBites. Both the tarffics, internet and intenal are routed through internet 256 Kbps bandwith but why I am getting different throughput. How can I improve the throughput of my tunnel to 20 to 25 KBites like normal normal internet browsing.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...