I recently had to extend my corporate network across the street to a new office we rented. During testing I noticed choppy VoIP calls Our only real option was to connect them via a set of wireless bridges so that's what we did.
I'm trying to setup QoS so that VoIP traffic isn't choppy during their massive file transfers. We're using Nortel phones so they don't really work the best with Cisco's normal auto-qos setup, and I'm not sure I really need L2 QoS anyways since it's only a single switch and across the L3 link is where I really need it anyways. If I could just prioritize entire VoIP subnet as it goes out the L3 interface to the wireless bridge, I think that would be good? I'm not quite sure how to set this up. Any reccomendations?
I attached a visio with port configs so you can how the network is setup. Ask away if you need more info.
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
Shape both sides to be less than available wireless bandwidth and use QoS to prioritize the VoIP.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...