I need to connect a 3500 XL switch with a Foundry Networks GIG SX switch. I see connectivity if i use one of the eth ports, but when I connect them using the Gigabit port the cisco switch doesn't show any connectivity at all. I know the Gb port is ok because I connected this switch to another cisco switch using the Gb port and works.
Make sure that the GBICs types on both the ends of the link are the same. Also, ensure that link negotiation enabled or disabled on both ends of the link. Both ends of the link must be set to the same value or the link cannot connect.
This document is a good reference when gig link between two devices does not come up.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...