Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

L3 SWITCHING

Can anyone tell me how I would go about using a L3 switch as a router, do I just need to anable ip routing and then assign an ip to one of the interfaces, using the no switchport command ?

thanks

Carl

1 REPLY
Red

Re: L3 SWITCHING

Yes, it's that simple. Not sure what type of L3 switch you are using, but the configuration steps are the same across the board.

Here is how it's done for the Cat4000 series (and would be the same for other L3 switches):

http://www.cisco.com/en/US/partner/products/hw/switches/ps663/products_configuration_guide_chapter09186a00800e467f.html

101
Views
0
Helpful
1
Replies
CreatePlease to create content