Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
295
Views
0
Helpful
2
Replies

LAM(Local-Area Mobility) issue

thomasl
Level 1
Level 1

‎12-25-2002 10:49 PM - edited ‎03-02-2019 03:48 AM

Hi,

I have 4 set of Catalyst 6509. Two set of them are one group. The other two are anohter group. Each gropu have several VLANs and configure HSRP in every VLAN. I enable LAM by config "ip mobile arp access-group 1" in some VLAN. The home agent is at group 1. I found that this function are OK in group 2. But, there are some problem in gropu 1. Sometime host's IP address can be add to routing table as host routing, but sometime it can't. I always find the ACL counter increase when host send ARP packet. Can anybody tell why?

Labels:
0 Helpful
2 Replies 2

wdrootz
Level 4
Level 4

‎12-31-2002 01:03 PM

Check to see if all four Catalyst 6509's are running the same IOS. If they are not running the same then try getting them all on the same IOS as the group that is working to see if there may be an issue with the other IOS.

0 Helpful

thomasl
Level 1
Level 1
In response to wdrootz

‎01-06-2003 05:18 PM

All Catalyst 6509 are the same IOS.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents