I have 4 set of Catalyst 6509. Two set of them are one group. The other two are anohter group. Each gropu have several VLANs and configure HSRP in every VLAN. I enable LAM by config "ip mobile arp access-group 1" in some VLAN. The home agent is at group 1. I found that this function are OK in group 2. But, there are some problem in gropu 1. Sometime host's IP address can be add to routing table as host routing, but sometime it can't. I always find the ACL counter increase when host send ARP packet. Can anybody tell why?
Check to see if all four Catalyst 6509's are running the same IOS. If they are not running the same then try getting them all on the same IOS as the group that is working to see if there may be an issue with the other IOS.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...