How would I interconnect 2 6509 core swithes to 3660 access router. The purposed design asked to create VLAN or VLANs for layer 2 devices to talk to layer 3 devices. I need to configure HSRP, multicasting, QoS for voice and video trafic. Do I need to do bridging, trunking or simple routing?. Sample config uration and some explanation would be helpful.
Lets see if this would make you understand my situation. How would I Interconnect 6509 for WAN traffic with 3660 access router. I got the inter VLAN routing part planed out. what would be the best solution bridging or routing to interconnect 6509 to access router 3660. Sample config..
ip address 10.27.80.145 255.255.255.252
bridge-group 1 input-type-list 202
Hopefully you understand now.......having problem to paste diagram. Thanks
HUGE problem with bridging and HSRP. I have twice seen an entire network go down once briding was enabled in an HSRP environment. Both routers are listening, only one is routing, however when a protocol is bridged, both routers listen and react to the traffic. I would not reccommend it.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.