I have a cisco 2621 Voice GW with a Voice T1 card. I have two cable modems in my office both being nat'd. I setup two IP routes on my cisco 2621 which looks like this:
ip route 0.0.0.0 0.0.0.0 192.168.1.1 50
ip route 0.0.0.0 0.0.0.0 192.168.1.2 100
Both these IP's are GW routers to my cable modem connection. Problem is when 192.168.1.1 goes down my calls are not routed over to the next IP route. How do I get it to failover to the next available connection?
My bad. I suggested HSRP cause I misunderstood the topology. I assumed that the static routes were on a different route than the cable connections. Is there any possibility to run a routing protocol between the 2600 and the provider?
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) email@example.com México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.