LAN-to-LAN files transference using Windows Network Drives
I have a problem when I am transferring or copying files between two LANs using Windows Network Drives (mapping drives), the files are not transferred or copied completely. I tried changing the MTU from 1500 to 3600 under the serial interfaces on the two routers of each network. The wan encapsulation is FrameRelay, look at the serial interfaces config:
no ip address
encapsulation frame-relay IETF
no ip mroute-cache
frame-relay lmi-type ansi
interface Serial0.1 point-to-point
ip address 10.252.130.13 255.255.255.252
no ip mroute-cache
no cdp enable
frame-relay interface-dlci 17 CISCO
priority-list 10 protocol ip high list 101
Any idea about how to avoid the interruptions while files are being copied?
Re: LAN-to-LAN files transference using Windows Network Drives
To pin point, whether its not a problem with the client, machines, can you try transferring files through drive mapping, on your local lan, from PC A to PC B and check to see if this problem exists ...
Windows file transfer uses SMB, which should be running over TCP/IP, and since you have Priority queueing, configured, for IP with more priority, this shouldnt be much of a problem.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...