The Processor in our core LANE card is running between 65 and 90% utilization. After reviewing the configs, I noticed that all our ATM subinterfaces have not only LANE server-bus services turned on, but also LANE client services for every elan on the network (even for the elans that don't have any ports attached to them on that switch) is that necessary? or can I turn off all the LANE client services except for on the elans that I need ports in?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...