Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

tim
New Member

Layer 3 Switching with DHCP and URT!

This is a bit of a complex one folks, I hope you can help!

Basically we have a fully switched network comprising of a mixture of 6509s and 6513s at the edge with a core of two, layer 3 6509s to facilitate inter VLAN routing. We are also running URT to provide security and DHCP to allocate subnets/VLAN accordingly. In addition we are using Policy manger for QoS, just to add to the fun. What I want to know is how the DHCP and URT side will actually work, i.e. how do the clients firstly get an IP that will allocate them to a logon VLAN and then pickup a IP for the correct VLAN, based on their logon credetials. I have some documentation of URT, but not al lot. Some detailed pointers on DHCP and URT in a Layer 3 environment would be very helpful.

Many thanks,

1 REPLY
New Member

Re: Layer 3 Switching with DHCP and URT!

81
Views
0
Helpful
1
Replies