I'm just wondering what would be the best way to implement leased line redundancy using serial connections.
have Site A (Main) and Site B (Branch). I have two links between both
but am currently only using one of these links. If link one failed I
want link two to kick in.
I am currently using static routes on the routers.
I will attach a network diagram showing the current setup.
Thanks in advance!
If you want to achive only active/standby configuration then configure one router as active and other one as stanby for lan traffic going out using HSRP implementation in lan side of both the routers making gateway as virtual ip of the group for lan subnet and also configure tracking along with IP SLA so in case of failover of the link automatically the standby router will be become active for lan user as tracking will decrement the pirporty of active router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...