I have recently installed a Cisco 1721 router for 512 kbps internet leased line. I want to install another internet leased line on the same router, but dont want the traffic from s0 to s1 or vice versa. I mean i want the traffic to remain seperate from each other.
Could anyone give me the required conf or access list statement.
You can not control the path the return traffic will take, but you can configure your router to policy route certain users out one serial link or another. For example, if you have a router with one ethernet and two serial links (assuming you have a class C network)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...