Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Leased Line Trafic manipulation

I have recently installed a Cisco 1721 router for 512 kbps internet leased line. I want to install another internet leased line (64kbps)on the same router, but dont want the traffic from s0 to s1 or vice versa. I mean i want the traffic to remain seperate from each other.

Could anyone give me the required conf or access list statement.

Thanks and with regards,

Miskin Mohiuddin.

3 REPLIES
Silver

Re: Leased Line Trafic manipulation

The requirement is no t very clear. Could you please provide some more input? Here are someconfiguration examples for access-lists:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipr_c/ipcprt1/1cfip.htm

Bronze

Re: Leased Line Trafic manipulation

sounds like you are trying to avoid becoming a transit area where traffic would come in one internet link and go out the other. this will not happen if you dont advertise anything but your own ip addresses. if you advertise what you learn from one link out the other then sites will think you can get them to those destinations. its not enough just to block the traffic when it gets to you because they will still tie up your link trying to reach the destinations you are advertising. Usually on small links like this you dont advertise anything, the isp handles that for you, so there should not be a problem.

New Member

Re: Leased Line Trafic manipulation

Hello, my name is Roger.

I suppose that you have a public range of addresses for internet access and a ip wan.

You have to define another NAT for this second serial interface and another pool.

To disgregate the LAN traffic you have to use an access-list to a range of private users. Put this access-list into a ROUTE-MAP and inside it use the command: set ip next-hope to enroute the traffic to this second interface.

Then apply this route map to the ethernet interface using the comand:

ip policy route-map [name].

You can communicate to may email:

roger.majo@t-empresas.com.pe

Best regards

88
Views
0
Helpful
3
Replies