You need to add a default route pointing to your gateway. On the layer 2 switch (depending on set based or ios based) the command for the gateway varies. This gateway address configured on the l2 switch is only used for switch generated traffic ( such as you telnet from the switch to an address outside the subnet of the ip address of the switch). To configure a l2 default gateway on cat 6000 the command is,
set ip route default [metric] [primary]
On a 2900, you can use the IOS based command "ip default-gateway "
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...