Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Level of privileges in the "enable password" command in Cisco Switches

Hello,

I would like to know if is possible, in a Cisco 4506, to set the 16 level of password privilege as with Cisco IOS.

Have you got any document that I can find in the Cisco site about this topic?

Thank you

Paolo

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Level of privileges in the "enable password" command in Cisc

The max and default level is 15. So you can't change it to 16. You can ener following command and see the max value.

access-sw-1-1(config)#privilege exec level ?

<0-15> Privilege level

To set the privilege levels, you can visit following url

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/supcfg.htm#1021512

1 REPLY
Cisco Employee

Re: Level of privileges in the "enable password" command in Cisc

The max and default level is 15. So you can't change it to 16. You can ener following command and see the max value.

access-sw-1-1(config)#privilege exec level ?

<0-15> Privilege level

To set the privilege levels, you can visit following url

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_1_11/config/supcfg.htm#1021512

205
Views
0
Helpful
1
Replies
CreatePlease login to create content