Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Limitation traffic in ATM interfaces

I have a atm interfaces and atm subinterfaces with several pvc on NRP card.

I need apply policing or shaping in this kind of interfaces, but not for pvc, I need to apply this limitation per interface and not for pvc.

Thanks so much,

Jorge

2 REPLIES
New Member

Re: Limitation traffic in ATM interfaces

ATM support per-pvc queueing, and it is recommended. If you need to rate-limit the subtinerface, rate-limit can be implemented.

http://www.cisco.com/en/US/products/hw/switches/ps718/products_configuration_guide_chapter09186a008009b009.html

New Member

Re: Limitation traffic in ATM interfaces

Hi Beng,

Thanks for your response.

But, the atm interfaces with pvcs are configured in NRP (6400), which is working like LAC of ADSL.

So, each pvc in atm subinterfaces belongs to ADSL client.

So, in order that car can take effect, I must configure in virtual-template, and I don´t want configure rate-limite in virtual-template, because it´ll affect to all subinterfaces and pvcs, and I want to apply limitation only for a few subinterfaces.

I hope to be clear.

Thanks so much,

Jorge.

83
Views
0
Helpful
2
Replies
CreatePlease to create content