Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Limiting Changes to switches via GUI

I would like to be able to let the PC support group to have access to the switches to change a port's VLAN and some of the other port settings and would like to do it via the GUI. We are using 3550 switchs for the most part. I know I can set up a lower privilege level and restrict the command set to only allow the commands I set but does anyone know of a way to restict the Cluster Management (GUI) interface to only allow limited changes. It seems to be only all or read only as the choices for the GUI. We have PC people here that get a scared look on their face when you mention telnet.

1 REPLY
Bronze

Re: Limiting Changes to switches via GUI

I strongly believe that it is not possible through GUI to give specific privilege logins.

80
Views
0
Helpful
1
Replies